Aileron And Flap Hinging - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

6. Use low-tack tape around the control horns to prevent epoxy
from getting on the control surface.
7. Use a square to check that the control horn is square to
the control surface. The slot in the control surface can be
carefully adjusted using a hobby knife.
8. Apply epoxy to the slot in the control surface. Make sure the
epoxy gets into the slot for a good bond between the surfaces
and control horn.
9. Apply epoxy to the area of the control horn that fi ts into the
slot. Apply epoxy to all the surfaces of the control horn that fi t
into the control surface.
10. Use a paper towel and isopropyl alcohol to remove any
excess epoxy.
EN
11. Before the epoxy fully cures, remove the tape from around
the control horn. This will allow the epoxy to fl ow around the
control horn, creating a small fi llet between the control horn
and surface for a fi nished look and secure bond. Allow the
epoxy to fully cure before proceeding.
 Use the control horns marked "F" and repeat the
previous section to install the flap control horns.

AILERON AND FLAP HINGING

12. Place a T-pin in the center of each hinge. This will keep the
hinges centered when they are installed.
13. Fit the hinge in the hinge slot. Align the slot in the hinge with
the hole in the wing. Install the hinges for the aileron and fl ap.
14. Fit the aileron into position on the hinges.
15. Fit the fl ap into position on the hinges.
6