Herunterladen Inhalt Inhalt Diese Seite drucken

Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung Seite 19

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

131. Fit the engine between the engine mounts. Adjust the engine
9
so the face of the drive washer is 5
/
-inches (141mm)
16
forward of the fi rewall.
 Use a clamp to hold the engine secure for the following steps.
132. Use a felt-tipped pen to mark the location for the four engine
mounting bolts on the engine mount.
133. Remove the engine from the mounts. Use a drill and
11/64-inch (4.5mm) drill bit to drill the holes for the engine
mounting screws.
134. Mark the location of the throttle pushrod on the fi rewall using
a sharpened wire or felt-tipped pen. Remove the engine from
the mount.
135. Use a drill and 5/32-inch (4mm) drill bit to drill the hole for
the throttle pushrod.
Pawnee Brave 20cc ARF
136. Slide the throttle pushrod tube into the hole in the fi rewall.
Once installed, the tube will protrude 1/16 inch (1.5mm) from
the fi rewall.
9
5
/
inches
16
(141mm)
137. Guide the pushrod tube through the fuselage toward the
throttle servo. Make sure the tube does not make any
extreme bends that could cause the pushrod to bind inside
the tube.
 The servo tray has locations on either side of the
fuselage for the throttle servo. Use the location that
best suits the engine selected for your model.
138. Trim the pushrod tube 1/4 inch (6mm) behind the former that
support the radio tray in the fuselage using side cutters. Use
medium CA to glue the tube in the fuselage.
 Make sure the CA does not enter the tube, which
could glue the pushrod wire to the tube.
139. Slide an M4 washer on each M4 x 30 machine screw,
then place an M4 locknut on each screw. Use a #2 Phillips
screwdriver and 7mm hex driver to tighten all four screws,
securing the engine to the engine mount.
19
EN

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Han7035

Inhaltsverzeichnis