Flap Servo Installation - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

35. Locate the linkage for the ailerons. With the clevis removed,
5
the linkage will measure 3 / inches (80mm).
32
 The clevis does not require removal.
This step is for reference only.
36. Insert the bend in the linkage through the hole in the servo
arm indicated in Step 34.
37. With the servo connected to the radio system, center the
servo using the radio system. Connect the clevis to the
control horn.
38. Adjust the linkage so the aileron aligns with the wing tip.
Pawnee Brave 20cc ARF
39. Once aligned, slide the silicone retainer over the forks of the
clevis. Thread the nut away from the clevis. Apply a small
drop of threadlock on the threads near the clevis. Use pliers to
tighten the nut against the clevis.
3 5 / inches (80mm)
32

FLAP SERVO INSTALLATION

40. Repeat the steps for installing the aileron servo to the servo
cover to install the fl ap servo.
 Set the flap travel to 0%, then attach the servo
arm 90-dgrees to the servo center line.
41. When attaching the linkage to the servo arm, use the hole
that is 13/16 in (21mm) from the center of the servo horn.
This hole will need to be enlarged using a pin vise and 5/64-
inch (2mm) drill bit.
42. Locate the linkage for the fl aps. With the clevis removed, the
linkage will measure 3
 The clevis does not require removal.
This step is for reference only.
43. Install the servo in the wing and secure the servo cover using
M2.5 x 10 self-tapping screws. Make sure to prepare and
harden the threads in the wood as outlined for the aileron
servo covers. Attach the linkage to the servo and control horn.
9
1
/ inches (90mm).
2
13/16 inch
(21mm)
3 1 / inches (90mm)
2
EN