Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung Seite 17

112. Use a #2 Phillips screwdriver to attach the X-mount to the
rear of the motor. Use a 2.5mm hex wrench to attach the
propeller adapter to the front of the motor. Use thread lock on
all metal-to-metal fasteners to prevent them from vibrating
loose.
113. Use two M4 x 20 socket head cap screws, two M4 washers
and two M4 lock nuts to temporarily attach the motor to the
motor box plate
114. Position the motor box plate fully forward when using
the recommended Spektrum Avian motor. The mount is
adjustable for a variety of motors.
115. Position the plate so the distance from the face of the drive
washer to the back of the motor box measures 5
(141mm)
116. Mark the location of the plate and remove the motor from the
motor box plate.
Pawnee Brave 20cc ARF
9
/ -inches
16
9
5 / inches
16
(141mm)
117. Slide the plate back and apply a thin coat of 30-minute epoxy
to the motor box where the plate comes in contact with the
box.
118. Slide the plate forward. Use a paper towel and isopropyl
alcohol to remove any excess epoxy. Use tape to hold the
sides of the motor box tight against the plate until the epoxy
fully cures.
119. Once the epoxy fully cures, remove the tape. Install the
triangle stock on the inside of the motor box. Make sure to
cut the triangle stock so it does not interfere with the holes
for mounting the motor and fi ts tight into the corners of the
motor box.
120. Attach the motor box to the fi rewall using four M4 washers
and four M4 x 20 socket head cap screws. Use threadlock on
the blind nuts to prevent them from vibrating loose.
121. Attach the motor box to the fi rewall using four M4 blind nuts,
four M4 washers and four M4 x 20 socket head cap screws.
Use threadlock on the blind nuts to prevent them from
vibrating loose.
17 EN