Rudder Installation; Tailwheel Installation - Horizon Hobby HANGAR 9 Pawnee Brave 20cc Bedienungsanleitung

74. Position the fi n back on the fuselage. Use a paper towel and
a small amount of isopropyl alcohol to remove any excess
epoxy from the fuselage and stabilizer before the epoxy
fully cures. Use low-tack tape to hold the fi n secure while
the adhesive fully cures. Allow the epoxy to fully cure before
proceeding.

RUDDER INSTALLATION

75. Use a hobby knife with a #11 blade to cut the slot in the
fuselage for the bottom rudder hinge.
76. Locate the control horn marked "R" for the rudder. Use
5-minute epoxy to glue the rudder control horn in position.
Allow the adhesive to fully cure before proceeding.
77. Hinge the rudder to the fi n and fuselage using the techniques
outline previously in this manual.

TAILWHEEL INSTALLATION

78. Place the tailwheel arm on the bottom of the rudder. Use a
felt-tipped pen to mark the locations for the mounting screws
on the rudder.
Pawnee Brave 20cc ARF
79. Use a drill and 1.5mm drill bit to drill the two holes for the
tailwheel arm mounting screws.
80. Thread an M2.5 x 10 sheet metal screw into each hole using
a #2 Phillips screwdriver
81. Remove the screws and apply 2-3 drops of thin CA into each
hole.
82. Once the CA has fully cured, attach the tailwheel arm to the
bottom of the rudder using the two screws and a #2 Phillips
screwdriver.
83. Place the M3 lock washers on the M3 x 12 tailwheel bracket
mounting screws.
13 EN