Intended Use; Reasonably Foreseeable Misuse; Avoiding Misuse - Optimum OPTIdrill D 17Pro Betriebsanleitung

1.3

Intended use

WARNING!
In the event of improper use of the drilling machine
will endanger personnel,

will endanger the machine and other material property of the operating company,

the correct function of the drilling machine may be affected.
The drilling machine is designed and manufactured to be used in a non-explosive environment.
The drilling machine is designed and manufactured for holes in cold metals or other non flam-
mable materials or that not constitute a health hazard using a rotating filing-stripping tool that
has a number of grooves for collecting the filings.
If the drilling machine is used in any way other than described above, modified without authori-
zation of Optimum Maschinen Germany GmbH, then the drilling machine is being used improp-
erly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee will expire, if any constructive, technical or proce-
dural changes are not performed by the company Optimum Maschinen Germany GmbH.
It is also part of the intended use that you
observe the limits of the drilling machine,

observe the operating instructions,

and comply with the inspection and maintenance instructions.


Technical specification on page 74
WARNING!
Extremely severe injuries.
It is forbidden to make any modifications or alternations to the operation values of the
drilling machine! They could endanger the personnel and cause damage to the drilling
machine.
1.4

Reasonably foreseeable misuse

Any use other than that specified under "Intended use" or any use beyond that described will be
deemed non-intended use and is not permissible.
Any other use must be discussed with the manufacturer.
It is only allowed to process metal, cold and non-inflammable materials with the drilling
machine.
In order to avoid misuse, it is necessary to read and understand the operating instructions
before first commissioning.
Operators must be qualified.
1.4.1

Avoiding misuse


Use of suitable cutting tools.

Adapting the speed setting and feed to the material and workpiece.

Clamp workpieces firmly and free of vibration.
ATTENTION!
The workpiece is always to be fixed by a machine vice, jaw chuck or by another
appropriate clamping tool such as for the clamping claws.
Safety
Version 1.0.3 - 2022-04-06 Translation of original instruction
D17 Pro│D23 Pro│D26 Pro│D33 Pro EN
65