Strain Gage Full Or Half Bridge And Piezo-Resistive Sensors In 6-Wire Configuration With Zero-Wire Teds, Version For D-Sub Plug (15-Pin) - HBM TEDS Montageanleitung

4.4 Strain gage full or half bridge and piezo-resistive sensors in 6-wire
configuration with Zero-Wire TEDS, version for D-sub plug (15-pin)
Measurement signal *
Measurement signal +
Sense lead *
Bridge excitation voltage *
Sense lead +
Bridge excitation voltage +
Fig. 2.11 Module wiring with a full bridge; with a half bridge, connection 4 is omitted
u
Push in the TEDS module between the soldered connections of the plug as shown in
Fig. 2.12 to Fig. 2.14.
8
15
Fig. 2.12 Mounting the TEDS module in the plug
u
Solder the connections to the solder tabs on the module.
TEDS
INSTALLATION AND CONNECTION
Zero-wire TEDS
rd
wh
AMP TD
gr
2' 2'
2 2
bk
1
gn
3' 3'
3 3
bl
Cable wire colors (HBM transducer):
bl = blue; gn = green; gy = gray;
rd = red; bk = black; wh = white;
1
9
2
4
3
13