Measurement
8
Measurement
8.1
Bleeding
To bleed the transducer before measurement, slacken the bleeder screw using
the 1.5 mm hex key and bleed the transducer. Then, tighten the bleeder screw
once more to a tightening torque of 0.6 N·m.
8.2
Setting the zero point
After installation, set the analysis unit so that it displays 0 bar gage pressure or
1 bar absolute pressure.
8.3
Rated output
To see the current pressure in bars, enter the appropriate rated output in your
analysis unit.
18
A05363_01_Y00_00 HBM: public
P60