HBM TEDS Montageanleitung Seite 23

IEEE bridge sensor template
Parameter
Transducer Electrical
Signal Type
Minimum Force/
Weight
Maximum Force/
Weight
Minimum Electrical
Value
Maximum Electrical
Value
Mapping Method
Bridge Type
Impedance of Each
Bridge Element
Response time
Excitation Level
(Nominal)
Excitation Level
(Minimum)
TEDS
TEDS TEMPLATES
1)
Value Unit
Bridge
Sensor
0.000 N
2.000k N
0.000 V/V
1.999m V/V
Linear
Full
345.0 ohms
1.00000 s
00u
5.0 V
0.5 V
Requires Explanation
rights at
level
ID This entry cannot be
changed.
CAL
The difference between
these values is the (positive)
maximum capacity
CAL
according to the data sheet.
CAL The difference between
these values is the
sensitivity according to the
CAL
data sheet or test record, or
from the calibration.
This entry cannot be
changed.
ID The bridge type. The
following values are
available for selection:
"Quarter" for a quarter
bridge, "Half" for a half
bridge, "Full" for a full
bridge. Some HBM trans­
ducers can be connected as
half bridges or full bridges
according to choice. For
HBM's SG-based
transducers, the bridge type
is always full bridge.
ID Input resistance according
to data sheet.
ID Irrelevant to HBM
transducers.
ID Nominal excitation voltage
according to data sheet.
ID Lower limit for the operating
range of the excitation volt­
age according to data sheet.
21