Product Variants And Scope Of Supply - HBM TEDS Montageanleitung

3

PRODUCT VARIANTS AND SCOPE OF SUPPLY

Most transducers can be ordered from HBM with a mounted TEDS module. In this case
the module is pre-wired and fully programmed.
To cover different applications, you can obtain different versions for self-assembly from
HBM. Zero-Wire and 1-Wire
and three rows of connectors. The variants are available with and without plugs; refer to
the following table. For measuring amplifiers with no connector plug, adapter cables with
open ends that fit the D-sub-HD15 plugs are also available, enabling you to mount the
TEDS module in a D-sub-HD15 plug and then connect it via the adapters. Alternatively,
you can use only the module for the D-sub-HD15 plug (Zero-Wire TEDS) or the 1-Wire
TEDS module with no plug.
Figure
TEDS
PRODUCT VARIANTS AND SCOPE OF SUPPLY
®
-TEDS are available for D-sub-HD15 plugs with both two
Scope of supply
D-sub-HD15
plug with
®
1-Wire TEDS
D-sub plug
15-pin with
®
1-Wire TEDS
D-Sub-HD15
plug with Zero-
Wire TEDS
D-sub plug
15-pin with
Zero-Wire TEDS
Ordering number
1-SUBHD15-MALE
1-SUBD15-MALE
1-TEDS-HDB-15P
1-TEDS-DB-15P
®
5