HBM TEDS Montageanleitung Seite 14

Fig. 2.9 View of the TEDS module in the plug from above with pin assignment
Fig. 2.10 View of the fully soldered plug
Important
For cable lengths above 50 m, you must loop resistors with half the bridge resistance of
the transducer into the sense leads; that is, solder one resistor each with R
the solder tabs and TEDS module in place of the jumper.
12
Cable wire colors (HBM transducer):
bl = blue; bk = black;
bl bk
Bridge excitation voltage *
Bridge excitation voltage +
/2 between
B
INSTALLATION AND CONNECTION
TEDS