HBM TEDS Montageanleitung Seite 32

IEEE template: Calibration Table
The template may exist in addition to the basic template. If the measuring amplifier is
able to analyze the template, you can use it to specify a more precise characteristic curve
in the form of a table. The values relate to the full measuring range of the sensor. Either
the electrical or the physical values are possible as correction values.
Important
The range to be specified for the TEDS always goes from 0% to 100%, meaning that if the
lowest value is -200 N, for example, it corresponds to 0% and not -100%. Even if the
highest value in this case were 0 N, it would correspond to 100%.
Parameter
Domain Parameter
of the Calibration
Table
Calibration Table
1. Domain
Calibration Point
(% of Full Span)
1. Range
Calibration
Deviation (% of Full
Span)
2. Domain
Calibration Point
(% of Full Span)
2. Range
Calibration
Deviation (% of Full
Span)
3. Domain
Calibration Point
(% of Full Span)
3. Range
Calibration
Deviation (% of Full
Span)
30
Value Unit
Physical
3
Elements
0.00 %
-0.0034 %
50.00 %
0.0000 %
100.00 %
-0.0276 %
Requires Explanation
rights at
level
CAL Possible values:
Electrical or Physical.
CAL Number of point pairs
specified.
CAL First value in percent of the
(full) measuring range for
which the table is applied.
CAL First value of the deviation from
the nominal in percent of the
(full) measuring range for
which the table is applied.
CAL Second value in percent of the
(full) measuring range for
which the table is applied.
CAL Second value of the deviation
from the nominal in percent of
the (full) measuring range for
which the table is applied.
CAL Third value in percent of the
(full) measuring range for
which the table is applied.
CAL Third value of the deviation
from the nominal in percent of
the (full) measuring range for
which the table is applied.
TEDS
TEDS TEMPLATES