HBM TEDS Montageanleitung Seite 12

Fig. 2.6 View of the TEDS module in the plug from below; pin 10 soldered on.
u
Turn the plug around and solder connection 1 (white) to pin 5 (Fig. 2.3).
This connects the measurement signals (output signals of the bridge).
Fig. 2.7 View of the TEDS module in the plug from above with pin assignment
(schematic)
u
Solder the supply voltage and sense leads to the four solder tabs (Fig. 2.7 and
Fig. 2.8).
u
Fix the cable with the cable clamp as shown in Fig. 2.8, and assemble the plug fully.
10
gn bl gr bk
Bridge excitation voltage *
Sense lead *
Bridge excitation voltage +
Sense lead +
Cable wire colors (HBM transducer):
gn = green; bl = blue;
gr = gray; bk = black;
INSTALLATION AND CONNECTION
TEDS