Safety During Maintenance; 1.13.1 Disconnecting And Securing The Geared Drill; Using Lifting Equipment; 1.14.1 Mechanical Maintenance - Optimum OPTIdrill DH 40G Betriebsanleitung

Observe the accident prevention regulations issued by your Employers Liability Insurance

Association or other supervisory authorities applicable to your company.
Inform the supervisor about all hazards or faults.

Stay on the geared drill until the machine completely stopped moving.

Use the specified personal protective equipment. Ensure you wear close-fitting clothing

and, if necessary, a hairnet.
Do not use protective gloves when drilling.

1.13

Safety during maintenance

Inform the operators in good time of any maintenance and repair works.
Report all safety relevant changes and performance details of the geared drill or their opera-
tional behavior. Any changes must be documented, the operating instructions updated and
machine operators instructed accordingly.

1.13.1 Disconnecting and securing the geared drill

Switch off the machine by turning off the master switch before starting any maintenance and
repair work.
Use a padlock to prevent the switch from being turned on without authorization and keep the
key in a safe place.
All machine parts as well as all dangerous voltages are switched off. Excepted are only the
positions which are marked with the adjoining pictogram.
Attach a warning sign to the machine.
1.14

Using lifting equipment

WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
Check that the lifting and load suspension gear

they have sufficient load carrying,

and that it is in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities applicable to your company.
Fasten the loads carefully. Never walk under suspended loads!

1.14.1 Mechanical maintenance

Remove or install protection safety devices before starting or after completing any mainte-
nance work; this include:
covers,

safety instructions and warning signs,

grounding cables.

If you remove protective or safety devices, re-fit them immediately after the completing the
work. Check if they are working properly!
1.15

Accident report

Inform your supervisors and Optimum Maschinen Germany GmbH immediately in the event of
accidents, possible sources of danger and any actions which almost led to an accident (near
misses).
There are many possible causes for "near misses".
The sooner they are notified, the quicker the causes can be eliminated.
EN
DH40G | DH40GP
58 Translation of original instructions
Safety
Version 1.0.1 - 2020-11-24