Safety During Operation; Safety During Maintenance; 1.16.1 Switching Off And Securing The Bench Drill B16H/ B16H Vario - Optimum OPTidrill B 16H Betriebsanleitung

OPTIMUM
M A S C H I N E N - G E R M A N Y
Personal protective equipment for special works
Protect your face and eyes: Wear a safety helmet with facial protection when performing works
where your face and eyes are exposed to hazards.
Use protective gloves when handling pieces with sharp edges.
Use safety shoes when you assemble, disassemble or transport heavy components.
1.15

Safety during operation

We specially point out the specific dangers when working with and on the bench drilling
machine.
WARNING!
Before switching on the bench drilling machine make sure that there are no

no dangers generated for persons,

not cause damage to equipment.
Avoid any risky working practices:

Make sure that nobody is endangered by your work.

The instructions mentioned in these operating instructions have to be strictly observed dur-
ing assembly, operation, maintenance and repair.

Do not work on the bench drilling machine, if your concentration is reduced, for example,
because you are taking medication.

Observe the accident prevention regulations issued by your Employers Liability Insurance
Association or other competent supervisory authority, responsible for your company.

Inform the supervisor about all endangerments or errors.

Stay at the bench drilling machine until all movements have come to a complete standstill.

Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work
suit and, if necessary, a hairnet.

Do not use protective gloves when drilling or milling.
1.16

Safety during maintenance

Inform the operators in good time about any maintenance and repair works.
Report all safety relevant changes and performance details of the bench drilling machine. Doc-
ument all changes, have the operating manual changed accordingly and train the machine
operators.

1.16.1 Switching off and securing the bench drill B16H/ B16H Vario

B16H
The bench drilling machine is equipped with
a main switch.
When the main switch is switched off, the
power supply to the machine is completely
interrupted.
GB B16H | B16HV
Page 64
®
Main switch
Translation of the original instructions
Img.1-6: Main switch B16H
Version 1.1.8 dated 2018-9-13
Safety