Set Up The Device; Power Supply - Heidolph Hei-MIX Titramax 100 Betriebsanleitung

Commissioning
Commissioning

Set up the device

CAUTION: Material damage, loss of production
Improper installation of the device may result in direct and indirect
damage to property due to falling and/or spilling of fluids!
➜
➜
➜
Place the device in a suitable workplace.
➜ The working surface must be even and flat.
➜ The device must be freely accessible at all times.
➜
Ensure that a sufficient safety distance can be maintained to moving and/or hot
components.
The professional mounting and positioning of the device including
the supplied accessories is within the sole responsibility of the
operator!
Heidolph instruments accepts no responsibility for direct and/or
indirect personal injury or damage to property resulting from failure
to observe the instructions for the correct mounting and positioning
of the device.

Power supply

DANGER
Electric Shock
The device may only be supplied with the required mains voltage
via a grounded mains socket-outlet (voltage see rating plate).
Connect the power supply cord
➜ Before connecting the power supply cord, make sure that the main switch of the
device is in position 0 (off).
➜ Connect the cable coupling of the supplied coded power supply cord (see figure) to
the IEC appliance inlet on the back of the device:
➜ Connect the power supply cord to a properly secured mains socket-outlet.
Observe the instructions for the correct positioning of the
device.
Observe the generally valid rules for the safe installation of
work equipment.
38