Inserting The Drive Battery In The Vehicle; Setting The Remote Control And Speed Controller - Reely Stagger Bedienungsanleitung

b) Inserting the drive battery in the vehicle
Important!
This vehicle accepts only one LiPo drive battery with 2 cells (rated voltage 7.4 V) or one NiMH drive battery
with 6 to 7 cells (rated voltage 7.2 V or 8.4 V), which are not included.
The use of several drive batteries would cause overloading of the vehicle drive and thus its damage (e.g.
differential). This will void the warranty/guarantee!
The drive battery type must match the speed controller/motor used. Make sure the undervoltage detection
on your speed controller is enabled if you are using a LiPo drive battery.
Loosen the two hook-and-loop straps on the battery holder. Insert the drive battery into the battery holder. Pull the two
hook-and-loop straps tight so that the drive battery is firmly held in place and fasten the hook-and-loop strap.
c) Setting the remote control and speed controller
The manufacturer's instructions and the relevant operating instructions must be strictly observed when setting the
remote control and programming the speed controller.
The steering must be set so that the model moves straight ahead when the steering control on the transmitter is in
the middle position. The steering angle to the right and left must be the same and the mechanical impact/blocking of
wheels at full steering angle must be excluded.
The speed controller must be configured in such a way that the motor is switched off and the vehicle is immobilised
when the drive function control on the transmitter is in the middle (neutral) position. In addition, the drive functions
such as forward drive, stop with brake function and reverse drive must be reliably detected by the speed controller so
that the motor is controlled accordingly.
Before testing the vehicle running performance, be sure to inspect the chassis and adjust, if necessary, as described
in the following sections.
56