Reely Stagger Bedienungsanleitung Seite 54

Assembly instructions, figure 45 (U-2):
Secure the LED bar to the body with two M2.5 x 12 screws. The power is supplied via the plug connected to a free
socket on the receiver (pay attention to correct polarity when plugging in). The cable can be fixed to the roll cage using
suitable cable fasteners.
Assembly instructions, figure 46 (V-1):
Fasten the two helmets to the dummy driver with two M3 x 8 screws.
Assembly instructions, figure 47 (V-2):
Fix the dummy driver to the body using four M2.5 x 8 screws.
Assembly instructions, figure 48 (V-3):
Now attach the complete body to the front of the chassis using two screws. Then snap shut the body and lock it with
the rotary knob.
54