Getting Started - Reely Stagger Bedienungsanleitung

10. Getting started

Follow exactly the procedure described below to ensure that the vehicle does not make uncontrolled movements
during commissioning.
• Just like the drive rechargeable battery, the batteries or rechargeable batteries in the transmitter must be full or
fully charged.
• Place the vehicle on a suitable surface so that the wheels can turn freely.
• Open the body, insert the fully charged drive battery into the battery compartment and secure it with the hook-and-
loop straps.
• Switch on the remote control transmitter.
• Connect the drive rechargeable battery to the speed controller. If the speed controller has an additional on/off
switch, turn it on. Do not reach into the drive and do not hold the vehicle by the wheels.
• Check the steering and drive functions as well as the neutral position of the drive (the motor must stop when you
release the throttle lever on the transmitter).
• Close the body.
• For the first test drive, choose a suitable terrain so that the model does not hit an obstacle immediately in the event
of a control error and thus become damaged.
• Start carefully until you get used to the driving behaviour of the vehicle.
• After the drive, first disconnect the drive rechargeable battery from the speed controller and then switch off the
remote control.
Important!
Never switch off the transmitter when the drive rechargeable battery is connected to the model or the model
is turned on.
61