Safety Instructions - Hbm U9C Montageanleitung

Safety instructions

1 Safety instructions
Intended use
The force transducers in the type series U9C are solely designed for
measuring static and dynamic tensile and compressive forces within the load
limits specified by the technical data for the respective maximum capacities.
Any other use is not the intended use.
To ensure safe operation, it is essential to comply with the regulations in the
mounting instructions, the safety requirements listed below, and the data
specified in the supplied technical data sheets. It is also essential to observe
the applicable legal and safety regulations for the relevant application.
Force transducers are not intended for use as safety components. Please also
refer to the "Additional safety precautions" section. Proper and safe operation
of force transducers requires proper transportation, correct storage, setup and
mounting, and careful operation.
Load-carrying capacity limits
The information in the technical data sheets must be observed when using the
force transducers. The respective specified maximum loads in particular must
never be exceeded. The following limits set out in the technical data sheets
must not be exceeded:
S Limit forces
S Lateral limit forces
S Bending moment and torque
S Breaking forces
S Permissible dynamic loads
S temperature limits
S Electrical load limits
Please note that when several force transducers are interconnected, the load/
force distribution is not always uniform.
4 U9C
A03815_03_YI0_01 HBM: public