Inline Amplifier - Hbm U9C Montageanleitung

Structure and mode of operation
4.3

Inline amplifier

The sensors can optionally be ordered with an inline amplifier. This amplifier
module supplies the bridge circuit of the sensors with a suitable supply voltage,
and converts the small output signal of the force transducers with low noise
into a 0 ... 10 V voltage signal (VA1) or a 4 ... 20 mA current signal (VA2). The
delivery is then carried out as a measurement chain, and the test record
describes the correlation between the force input quantity and the output signal
in V or mA.
U9C 13
A03815_03_YI0_01 HBM: public