What To Do If; Technical Specifications Rollotube X-Line - RADEMACHER X-line Handbuch

i

What to do if... ?

...the motor fails to start?
Possible cause:
◆ Mains power not available.
Solution:
◆ Check the power with a meter to ensure that the supply voltage (230 V/50 Hz)
is available and check the wiring.
◆ Observe especially the information relating to impermissible connection types.
...The tubular motor stops after a short period of time during the
configuration and test procedures?
Possible cause:
◆ The adapter (10) may have slipped off of the limit ring (19) on the drive head (12).
Solution:
◆ Check that the adapter (10) sits flush with the drive head (12) and is fully inserted
into the rotating union (5).
◆ Slide the adapter (10) back so that it is flush with the drive head (12) and slide
the rotating union (5) fully onto the adapter (10), see Figure  . Re-adjust the end
points if necessary, see page 59.
...Automatic adjustment of the lower end point does not work.
Possible cause:
◆ The catch (8) is mounted without the freewheel mechanism.
Solution:
◆ Configure the lower end point manually (see pages 63 and 64).
i

Technical specifications RolloTube X-line

Motor series
Type:
66
Medium
15/16Z 25/16Z 35/16Z 45/12Z
15 25 35 45
16 16 16 16
230 230 230 230
50 50 50 50
145 191 198 205
0.64 0.83 0.86 0.89
4 4 4 4
4 4 4 4
0.75 0.75 0.75 0.75
3 3 3 3
32 32 32 32
H H H H
I I I I
IP 44 IP 44 IP 44 IP 44
PVC PVC PVC PVC
487 546 546 546
45 45 45 45
≤ 70 ≤ 70 ≤ 70 ≤ 70
...The tubular motor stops between the two end points during normal
operation?
Possible cause 1:
◆ The bearing capsule (4) may not be secured with a screw to the rotating union (5)
(see Figure ), causing the rotating union (5) to slip from the motor and the
adapter (10) to come away from the limit ring (19) on the drive head (12).
Solution 1:
◆ Check for correct fitting of the bearing capsule (4) and the adapter (10). Use a
self-locking bolt to secure the bearing capsule (4) to the rotating union (5) and
remount the motor in accordance with the information on pages 52 - 56.
Possible cause 2:
◆ The thermal protection system has triggered.
Solution 2:
◆ Wait approx. 20 minutes until the motor has cooled down.
...The roller shutters stop during upward or downward travel?
Possible cause:
◆ Iced-up roller shutters or obstacle on the guide rail.
Solution:
◆ Move the roller shutters a short distance in the respective opposite direction.
◆ Rectify iced-up roller shutters or obstacle.
Nm Rated torque:
RPM No-load speed:
V Rated voltage:
Hz Frequency:
W Rated output:
A Power consumption:
Min. Cyclic duration factor (KB):
Number of wires:
mm Core cross section:
2
m Cable length (standard):
R Limit switch range: (number of revolutions)
Insulation class:
Protection class:
Protection class in accordance with VDE 700:
Conduction class:
mm Motor length without bearing:
mm Tube diameter:
dB(A) Noise pressure level (LpA):
EN