What To Do If - RADEMACHER RolloTube S-line Sun DuoFern Original - Betriebs- Und Montageanleitung

i

12. What to do if... ?

...the motor fails to start?
Possible cause:
◆ The mains voltage is not available.
Solution:
◆ Check the power with a meter to ensure that the
supply voltage (230 V) is available and check the
wiring.
◆ Observe especially the information relating to
impermissible connection types.
...the wiring is incorrect?
Possible cause:
◆ The control lines are mixed up.
Solution:
◆ Disconnect the lead from the mains and ex-
change the wires for
...the tubular motor stops after a short period of
time during the setting and test procedures?
Possible cause:
◆ The adapter (8) may have slipped off the magnetic
ring (14) on the drive head (6).
Solution:
◆ Check that the adapter (8) sits flush with the drive
head (6) and is fully inserted into the awning shaft
(11).
◆ Slide the adapter (8) back so that it is flush with
the drive head (6) and then press the tubular mo-
tor into the awning shaft (11) so that the adapter
(8) is inserted fully in the awning shaft, see illustra-
tions [ 3 / 8 ]. Re-adjust the end points if necessary,
see page 61.
...the tubular motor stops between the two end
points during normal operation?
Possible cause:
◆ The thermal protection system has triggered.
Solution:
◆ Wait approx. 20 minutes until the motor has
cooled down.
...the tubular motor stops whilst extending the
awning?
Possible cause:
◆ The motor must push the awning out because
the awning shaft (11) is not running smoothly or
is corroded.
Solution:
◆ Check/restore the free movement of the awning
or consult a specialist awning firm.
L1 and L1 .
... the tubular motor continues to retract the
awning after the tensioning of the fabric during
the automatic outer end point setting?
Possible cause:
◆ The tubular motor may be over-dimensioned.
Solution:
◆ The outer end point must be set manually in this
case.
... the tubular motor cannot retract the
extended awning again?
Possible cause:
◆ The tubular motor may be under-dimensioned.
Solution:
◆ Use a tubular motor with a more powerful driv-
ing force.
... the fabric has become very loose and blocked
over the extended awning arms during the
manual end point setting?
Solution:
◆ At this point, perform a new top end point set-
ting or a factory reset.
EN
65