Dismounting The Catch (Figure ); Sliding The Tubular Motor Into The Rotating Union (Figure  ); Preparation For Use Of Precision Tubes (Figures ) - RADEMACHER X-line Handbuch

Dismounting the catch (Figure
4.c
(7)
Sliding the tubular motor into the rotating union (Figure  )
1. First slide the catch (8) into the rotating union (5).
IMPORTANT
The motor (9) must have sufficient free space for rotating unions with internal felt.
Preparation for use of precision tubes (Figures
IMPORTANT
◆ Please only use precision tubes made from aluminium.
◆ The following steps can be left out when using octagonal steel shafts.
5.a
54
)
(8)
(20)
Never knock the motor (9) with force
into the rotating union (5).
Doing so will cause serious damage.
ALUMINIUM
1. Press the side parts of the retaining clip (7) together and pull the catch
(8) off of the drive adapter (20).
2. Subsequently, press the rotating union (5) fully onto the adapter (10).
IMPORTANT
In doing so, ensure that the adapter (10) does not slip off of the limit ring (19) on
the drive head (12) during the assembly process. Otherwise malfunctions may occur,
see page 66.
-
)
1. Measure the distance between the adapter (10) and the rear third of
the catch (8) and mark this distance on the precision tube.
EN