Setting the parameters / General settings (roller shutter)
Menu
Motor controls
Use scenes (see chapter „Scenes")
Transmission delay of switching / status outputs after restoration of voltage
NOTE
If awning has been selected, you will find all necessary settings from page 79 onwards.
Roller shutter control / Roller shutter drive mechanism
The specific characteristics of the connected drive are detailed here.
Menu
Exchange Up/Down
Use tilting *
Automatic length balancing of hangings *
If „Yes":
After the following cycle count
Send drive position after change
If „Yes":
Transmission delay of the position in 0,1 sec
* see page 51 (Functional description)
Settings
Roller shutter • Awning
No • Yes
5 sec ... 2 h
Settings
No • Yes
No • Yes
No • Yes
10 ... (32) ... 40
No • Yes
0 ... (10) ... 50
EN
71