Activate Registration Mode For The X-Line Tubular Motor With A; Cord Circuit Setting Unit Or With An External Switch - RADEMACHER X-line Handbuch

Activate registration mode for the X-line tubular motor with a

cord circuit setting unit or with an external switch

1.
2.
SET
3.
SET +
3.1
SET
4.
68
Symbols and actions when connecting a cord circuit setting unit (23).
or
when connecting an external switch.
Switch on the mains power.
or OFF
If a cord circuit setting unit (23) is being used, then the rocker switch must be positioned to the centre position.
Press and hold the SET button or the external switch.
or
Additionally switch on the mains power.
or
+
After approx. 5 seconds the tubular motor is briefly running by way of acknowledgement.
ON
Release the SET button or the external switch as soon.
or
The motor is now in registration mode.
NOTE
If you hold the keys down for a total of more than 10 seconds, manual end point setting is activated.
Now the physical address can be assigned for the X-line tubular motor.
Once the physical address has been input, the set but (11) LED goes out.
NOTE
If you have unloaded the application, registration mode cannot be started by means of the set button. Please use the „physical address"
diagnostic function in the ETS software.
EN