Lldp Admin-State; Lldp Fdb-Mode - Hirschmann Automation GRS1040 Bedienungsanleitung - Referenz-Handbuch

Link Layer Discovery Protocol (LLDP)
52.3 lldp
52.3 lldp
Configure of Link Layer Discovery Protocol on a port.
52.3.1

lldp admin-state

Configure how the interface processes LLDP frames.

Mode: Interface Range Mode

Privilege Level: Operator

Format: lldp admin-state <P-1>
Paramete Value
r
tx-only
P-1
rx-only
tx-and-rx
disable
52.3.2

lldp fdb-mode

Configure the LLDP FDB mode for this interface.

Mode: Interface Range Mode

Privilege Level: Operator

Format: lldp fdb-mode <P-1>
Paramete Value
r
lldp-only
P-1
mac-only
both
auto-detect
488
Meaning
Interface will only transmit LLDP frames. Received frames are
not processed.
Interface will only receive LLDP frames. Frames are not
transmitted.
Interface will transmit and receive LLDP frames. This is the
default setting.
Interface will neither transmit nor process received LLDP
frames.
Meaning
Collected remote data will be based on received LLDP frames
only.
Collected remote data will be based on the switch's FDB entries
only.
Collected remote data will be based on received LLDP frames as
well as on the switch's FDB entries.
As long as no LLDP frames are received, the collected remote
data will be based on the switch's FDB entries only. After the
first LLDP frame is received, the remote data will be based on
received LLDP frames only. This is the default setting.
RM CLI HiOS-3A-MR GRS1040
Release 6.1 09/2016