Garp Interface Leave-All-Time - Hirschmann Automation GRS1040 Bedienungsanleitung - Referenz-Handbuch

27.2.3

garp interface leave-all-time

Set the GARP leave-all time-interval. The leave all timer controls the frequency with which the leaveall
state machine generates leaveall PDUs. The timer is required on a per-Port, per-GARP Participant
basis.

Mode: Interface Range Mode

Privilege Level: Operator

Format: garp interface leave-all-time <P-1>
Paramete Value
r
200..6000
P-1
27.2.4 garp gvrp operation
Enable or disable GVRP on the port. When enabled, globally and on this port, the device distributes
VLAN membership information to GVRP aware devices connected to this port.

Mode: Interface Range Mode

Privilege Level: Operator

Format: garp gvrp operation

no garp gvrp operation
Disable the option

Mode: Interface Range Mode

Privilege Level: Operator

Format: no garp gvrp operation
27.2.5 garp gmrp operation
Enable or disable GMRP on the interface, with GMRP enabled globally and on this interface, the device
sends and receives GMRP messages on this port.

Mode: Interface Range Mode

Privilege Level: Operator

Format: garp gmrp operation
RM CLI HiOS-3A-MR GRS1040
Release 6.1 09/2016
GARP VLAN and Multicast Registration Protocol (GVRP and GMRP)
Meaning
Leave-All time-interval in centi-seconds.
27.2 garp
287