Connecting To The Prosthesis During Normal Operation; Charging The Remote Control - Ottobock Genium Gebrauchsanweisung

4. Use the enter key to confirm once another prosthesis has been found. If several additional prostheses are found,
the serial number of the desired prosthesis has to be entered using the navigation keys (display: serial number).
Use to select one of the four items and confirm with the enter key. One of the existing connections can also
be overwritten. The configuration files are loaded from the prosthesis and the main menu is displayed.
To delete an existing connection, please follow the steps below:
1. In the main menu, use
2. In the menu that appears, select "DELETE CONNECTION" and confirm using the enter key.
3. Select the connection you wish to delete using
7.11 Connecting to the Prosthesis during Normal Operation
INFORMATION
Advise your patient of the information in this section.
If more than one connection has been saved, a selection menu for the saved connections appears after powering up;
the most recently active connection is pre-selected here.
1. To change the active connection, select the name of the current connection in the main menu and press the enter
key to confirm.
2. In the list of saved connections which is then displayed, select the required connection and press the enter key to
confirm.
3. If the chosen connection cannot be re-established, a reduced main menu appears. Choose "SELECT DEVICE"
to activate another selected connection. In some cases following service, the connection cannot be restored even
though the joint is within range of the remote control. In this case, the existing connection must be erased and the
pairing process has to be completed again.
7.12 Charging the Remote Control
INFORMATION
Advise your patient of the information in this section.
Disconnect the charging cable from the charger for the 3B1/3B1=ST Knee Joint and connect it to the charging re-
ceptacle of the remote control. Depending on how often the remote control is used, it should last two months on a
single charge. The battery charge level of the remote control is shown at the top left of the display (see Fig.1, Section
7.3 "Initial Connection of the Remote Control and the 3B1/3B1=ST Knee Joint (Pairing)"). Fully charging the remote
control battery takes a maximum of 3-4 hours.
Genium - Bionic Prosthetic System Genium - Bionic Prosthetic System
to select „RC SETTINGS" (remote control settings) and press the enter key to confirm.
and confirm with the enter key.
Remote Control Remote Control
Ottobock | 59 Ottobock | 59