Querying The Prosthesis Status - Ottobock Genium Gebrauchsanweisung

Proceed as follows to activate deep sleep mode:
1. Select "DEVICE SETTINGS" from the main menu and confirm.
2. A list of the adjustment parameters available for the current MyMode is displayed. The entry "DEEP SLEEP" is at
the end of this list; select it and press the enter key.
3. A confirmation message is displayed. Press the enter key again.
• Feedback from the prosthesis: 1 short beep signal
Proceed as follows to wake the knee using the remote control:
1. Activate the remote control by pressing the enter key and
2. Select the "DEVICE POWER ON" menu entry and press the enter key to confirm.
3. The knee joint is reactivated after 20 seconds at the latest with a single beep and vibration signal. The knee joint
is then in basic mode again.
Alternatively, the knee joint can be woken by connecting the charger.
INFORMATION
Deep sleep mode is not available if the joint is in safety mode.
7.8 Querying the Prosthesis Status
INFORMATION
Advise your patient of the information in this section.
1. Selecting and confirming "STATUS" displays the following:
• The total pedometer value ("STEP")
• The daily pedometer value ("TRIP")
• The charging state of the prosthesis in percent ("BATT.")
• The estimated remaining operating time of the prosthesis in hours during active use and at rest (e.g. sitting func-
tion) ("STB/ACT" for Standby/Active).
• The next service due date
2. Selecting "TRIP" and pressing the enter key resets the day step counter.
Genium - Bionic Prosthetic System Genium - Bionic Prosthetic System
and 1 short vibration signal
.
Remote Control Remote Control
.
Ottobock | 57 Ottobock | 57