Parameter
Volume
8.2.3 Overview of adjustment parameters in MyModes
The parameters in the MyModes describe the static behaviour of the prosthesis for a specific
motion pattern such as cross-country skiing. Damping behaviour is not automatically controlled
and adjusted in MyModes.
The following parameters can be modified in MyModes:
Parameter
Gain
Volume
8.3 Turning Bluetooth on the prosthesis on/off
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
establish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 71).
8.3.1 Switching Bluetooth off/on using the cockpit app
Switching off Bluetooth
1) When the component is connected, tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Functions".
3) Tap the entry "Deactivate Bluetooth".
4) Follow the on-screen instructions.
Switching on Bluetooth
1) Rotate the component or connect/disconnect the battery charger.
Adjustment
Setting
software
range, app
range
0 to 4
0 to 4
Adjustment
Setting
software
range, app
range
0 to 100
+/- 10
0–4
0–4
Meaning
Volume of beep signal for confirma
tion tones (e.g. when checking the
charge level, switching MyModes).
The "0" setting deactivates the aud
ible feedback signals. However, warn
ing signals are still generated if errors
occur.
Meaning
Value for speed at which flexion resist
ance increases as the knee angle
increases
Volume of beep signal for confirma
tion tones (e.g. when checking the
charge level, switching MyModes).
The "0" setting deactivates the aud
ible feedback signals. However, warn
ing signals are still generated if errors
occur.
71