Zimmer Air Dermatome II Bedienungsanleitung Seite 6

CLEANING AND DISINFECTION PROCESS INSTRUCTIONS FOR
THE DERMATOME II (SEE FIGURES 10-13)
The following instructions and chart detail the cleaning and disinfection process for the Zimmer Air Dermatome II.
• Use caution when handling the dermatome to determine that the used blade has been removed. If not,
safely dispose of all used blades in accordance with hospital policy for contaminated waste and sharps.
• Universal precautions for handling contaminated/biohazardous materials should be observed.
• Instruments should be cleaned within 30 minutes of use to minimize the potential for drying prior to
cleaning.
• Prior to cleaning, remove width plate from device and clean separately.
• Follow the Cleaning Instructions found in Chart 1 or Chart 2 for the Dermatome II handpiece and width
plate.
• Zimmer Air hose may be wiped down and/or manually cleaned with isopropyl alcohol or silicon rubber
compatible cleaner. Do not submerge the hose in liquids or automatic wash.
• Following the cleaning procedure, visually inspect for damage and/or wear.
• Prepare cleaning agents at the use-dilution and temperature recommended by the manufacturer.
• The thickness control lever should be moved during cleaning to release any debris which may be trapped
under the lever or in the notches.
• Careful attention must be made to joints, mated areas, and cavities while cleaning the device. Verify all
visible soil has been removed from these areas, especially the drive pin cavity located at the bottom of the
device.
• Check the action of moving parts to ensure smooth operation throughout the intended range of motion.
Note: If damage or wear is noted that may compromise the function of the instrument, do not use. Refer to RETURN
AUTHORIZATION AND REPLACEMENT INFORMATION section.
• Steam sterilize only. Follow instructions in STERILIZATION RECOMMENDATIONS.
6