D) Switching On The Quadrocopter - Reely 1998713 Bedienungsanleitung

d) Switching on the quadrocopter

So that the receiver in the quadrocopter can respond to the transmitter signals, the receiver and the transmitter must
have the same digital coding (pairing). For this reason, it is important that you switch the quadrocopter on as described
below.
Important!
There should be no other 2.4 GHz transmitters in the immediate vicinity during the switching on process.
Step 1: Now move the joystick for the pitch and yaw func-
tion (see also Figure 9, no. 5) to the lowest position = mo-
tor off position (Figure 10).
Step 2: Place the quadrocopter on a horizontal and
smooth surface (tabletop or similar).
Step 3: Use the on/off switch to switch on the quadrocop-
ter. To do this, slide the switch from the "OFF" position to
the "ON" position (Figure 11).
The three white LEDs on the quadrocopter will start to
flash. This indicates that the quadrocopter is waiting for
the transmitter signal.
Step 4: Now switch on the transmitter by briefly pressing
the on/off switch (see Figure 12, no. 4).
The transmitter emits a short beep and the LED indicator
light on the transmitter (see also Figure 9, no. 3) starts
to flash.
The three white LEDs on the quadrocopter glow stead-
ily when the quadrocopter has detected the transmitter
signal.
Step 5: Move the joystick for the pitch and yaw function
to the highest position (full throttle) (see Figure 12, no. 5).
The transmitter emits a short beep again.
Step 6: Move the joystick for the pitch and yaw function to
the lowest position (motor off position) (see Figure 12, no.
6). The transmitter emits a long beep and the LED indica-
tor light on the transmitter glows steadily.
The quadrocopter is now ready for take-off and
responds to the control commands of the trans-
mitter.
Figure 10
Figure 11
Figure 12
53