Inserting Batteries Into The Remote Control - Reely 1998713 Bedienungsanleitung

8. Inserting batteries into the remote control

The numbers used in these instructions refer to the illustration alongside the text or the illustrations within
the respective section. Cross-references to other figures are indicated with the corresponding figure num-
ber.
Two AAA/Micro batteries are required to power the transmitter (not included and must be ordered separately).
Important:
Use only standard batteries (1.5 V/cell) and not rechargeable batteries (1.2 V/cell) as the power supply for
the transmitter.
To insert the batteries, proceed as follows:
Loosen the retaining screw (1) on the battery compart-
ment cover (2) on the back of the transmitter with a suit-
able screwdriver.
Push down the locking latch (3) of the cover lock and slide
out the battery compartment cover.
Insert two AAA/Micro batteries into the battery compart-
ment, observing the correct polarity (4), as shown in the
diagram. The spiral spring contact (5) must always be con-
nected to the negative pole of the battery.
Replace the battery compartment cover and allow the
locking mechanism to lock into place in the transmitter
housing.
Re-tighten the retaining screws.
48
Figure 1
Figure 2