Reely 1998713 Bedienungsanleitung Seite 64

Place the wing on the hooks (1) so that all hooks sit in
the wing openings (squeeze the hooks together).
Then carefully push the fuselage forward (2) so that the
two parts are connected.
Finally, mount the tailplane on the rear (3). Carefully
bend it apart and slide it onto the fuselage so that the
front part sits in the opening (4). It can later be used to
set the tailplane.
If the guard is mounted on the quadrocopter, remove
it now.
Then insert the quadrocopter into the holder. It enclos-
es the quadrocopter's fuselage in the middle.
Important!
The quadrocopter must be used in such a
way that the on/off switch points upwards.
One of the three transparent plastic clips included is
fastened to the holder (see Figure 26) so that the quad-
rocopter cannot come loose from the holder.
The other two plastic clips serve as spare parts if
needed.
The clamps on the left and right of the holder are in-
serted into the slot-shaped openings of the plastic clips
and hooked.
64
Figure 24
Figure 25
Figure 26