Reely 1998713 Bedienungsanleitung Seite 51

Each clip has a small round latch on the left and right,
which must be pushed into a corresponding opening (see
arrows in Figure 7) next to the drive motor.
Figure 8 shows the correctly secured clips.
Do not use force when attaching the guard and pushing
the latches into the openings.
If the guard is to be removed again later on, proceed in
reverse order. For each of the four clips, first remove the
two round latches from the quadrocopter housing (insert
your fingernail between the clip and the wing and gently
pry the clips out). Then the clip can be unhooked from the
wing. After disengaging the fourth clip, the guard can be
removed.
Figure 6
Figure 7
Figure 8
51