Werbung
IMPIANTO ELETTRICO
ELECTRIC SYSTEM
INSTALLATION ELECTRIQUE
ELEKTRISCHE ANLAGE
+-
INSTALACION ELECTRICA
Headlamp adjustment
The front headlamp is fitted a dipping bulb for main and dipped beams and a pilot/sidelamp
bulb.
Particular care should be taken to adjust the headlamp beam; adjust as follows:
- position the motorcycle at 33 ft from a flat wall;
- check that the bike is on a level surface and that the headlamp axis is at rightangles to the
wall;
- the bike should be in a vertical position;
- measure the distance from the ground to the centre of the headlamp lens and thenmark a
cross at the same height on the wall;
- switch on to dipped beam; the upper limit of the beam should be at a heightwhich is so
greater than 9/10 of the height from the ground of the centre ofthe headlamp. Adjust the
headlamp aiming by turning screw (1) to lower or lift the highbeam.
Headlamp bulbs replacement
To gain access to the healamp bulbs, proceede as follows:
- remove the upper fastening screw of the the headlamp carrier to the instrument panuel
support (A);
- push forward the headlamp carrier (B) and pull it towards the high (C) in order to uncouple
from the two lower supports.
- remove the headlamp carrier;
- remove the two filaments bulb (7) connector (2) and the boot (3);
- remove the screw (6);
- release the bulb holding spring (4) and then the bulb itself.
To replace the parking light bulb (5) extract it from the inside cover.
After replacement, reverse operations for reassembly.
Rear tail light bulb replacement
To gain access to the tail light bulb (12V-5/21W), proceed as follows:
- remove the two fastening screws (1) in the inner side of the rear fender and the lens(2);
- pull the lamp (3) inside, turn it counterclockwise then remove it from the lamp holder.
After replacement, reverse operations for reassembly.
Make sure not to tighten the screws excessively.
Rear stop light bulb replacement (Enduro USA/ CDN)
To gain access to the stop light bulb (12V-3W), proceed as follows:
- remove the two fastening screws (1) and the rear lens (2);
- extract the bulb (3) turn and replace it.
After replacement, reverse operations for reassembly.
Make sure not to tighten the screws excessively.
M.27
8000H1605 (07-09)
Werbung
Kapitel
