Throttle Cable Adjustment - Husqvarna TE 125 2012 Bedienungs- Und Wartungsanleitung

WARNING
Avoid removing radiator cap (5) when
engine is hot, as coolant may spout out
and cause scalding.
WARNING
Because the cooling fan (6) can be acti-
vated even when the start switch is in
OFF position, always keep at a safe dis-
tance from the fan blades.
Note *:
Difficulties may arise in eliminating coolant from painted
surfaces. If this occurs, wash off with water.
5
6
EN - 22 SPECIFICATIONS - OPERATION - MAINTENANCE

THROTTLE CABLE ADJUSTMENT

To check the correct adjustment of the throttle cable, op-
erate as follows:
- loosen screw (1) and remove the protection cover
(2);
- turn throttle twistgrip (3) and make sure it has about
0.08 in. (2 mm) free play;
- if it is not so, loosen the lock nuts (4) and suitably
turn the adjuster screws (5) (loosen to decrease play
or tighten to increase it);
- tighten back the lock nuts (4);
- reassemble all parts, in the reverse order compared
to disassembly.
WARNING*: Operation with damaged
throttle cable could result in an unsafe
riding condition.
WARNING*: Exhaust gas contains poi-
sonous carbon monoxide. Never run the
engine indoors.
1
4
2
3
( 0.08 in.)
5