Werbung
IMPIANTO ELETTRICO
ELECTRIC SYSTEM
INSTALLATION ELECTRIQUE
ELEKTRISCHE ANLAGE
+-
INSTALACION ELECTRICA
1- SPEED (Km/h or mph) / ODO (figure 1)
- SPEED: motorcycle speed- maximum value: 299 Km/h or 299 mph;
- ODO: odometer- maximum value: 99999 km;
To replace kilometers with miles or miles with kilometers proceed as follows:
1) set to figure 1, stop the engine and push the knob SCROLL (A);
2) Start the engine holding pushed the button SCROLL (A) until the symbol
"Km/h" will be displayed;
3) then the symbols "Km/h" and "Mph Miles" will be displayed alternatively. Push
again the SCROLL (A) button
when the unit you wish to use is displayed.
2-2- SPEED / CLOCK (figure 2)
- SPEED: motorcycle speedmaximum value: 299 Km/h o 299 mph;
- CLOCK: clock- Reading from 0:00 to 23:59:59;
To reset the clock, push the knob SCROLL (A) for more than 3 seconds in order to
increase the hours; release the knob and then, after 3 seconds, it is possible to
increase the minutes;
3- SPEED / TRIP 1 (figure 3)
- SPEED: motorcycle speedmaximum value: 299 Km/h o 299 mph
- TRIP 1: distance- maximum value: 999.9 km (the data will be lost with voltage
lower than 6V).
To setup the TRIP, push the SCROLL (A) button holding down more than 3 seconds.
4- SPEED / CHRONO (STP) (figure 4)
- SPEED: motorcycle speedmaximum value: 299 Km/h o 299 mph;
- STP 1: miles/kilometers covered time;
- Reading from 0:00 to 99:59:59 (the data will be lost with voltage lower than
6V).
To activate the function STP 1, push the knob SCROLL (A) for more than 3
seconds.
- 1st step: function ON;
- 2nd step: stop to the counters;
- 3rd step: STP 1 zero-setting; TRIP 1 and AVS 1 data zero-setting;
- 4th step: function ON;
- 5th step: stop to the counters;
.............................
and so following
M.19
8000H1605 (07-09)
Werbung
Kapitel
