Troubleshooting - Frigomat Kikka 3P-Serie Gebrauchsanweisung Und Wartungshandbuch

7.2 TROUBLESHOOTING

TROUBLE
The machine does not start up
(STOP pushbutton ON without
active alarms)
The machine does not start up
(STOP pushbutton OFF)
Since the beginning of the freezing
cycle, the compressor works
intermittently
Presence of liquid ice-cream in the
drip drawer
Production times grow longer and
the ice-cream looks wet.
During freezing the machine
becomes noisy and the beater
stops.
During washing with water, the
CONSERVATION pushbutton
blinks and no function is enabled
POSSIBLE CAUSES
Electric trouble or failed safety
microswitch
Incorrect power supply
Wrong door assembly
Master switch OFF or incorrect
power supply
Blown fuse
Faulty electronic card or
pushbutton
(Mod. water) Lack of condensing
water
(Mod. air) Dirty air condenser or
faulty fan.
Worn out stuffing box
Worn out scraping blades
Faulty cooling system
The mixture is not suitable
Excessive product dispensing
Wrong assembly of the pump or of
the feeding needle.
Insufficient feeding of the cylinder
Wrong assembly of beater
scraping blades
Wrong regulation of the pump or of
the feeding needle
Too warm washing water
REMEDIES
Call for the technician
Check the phases.
Check the door.
Close the switch and check the
phases
Check and replace it (call for the
technician)
Call for the technician
Check for the presence of water in
the water supply system to which
the machine is connected. Check
for the taps. Check that the
discharge is not obstructed.
Clean the condenser with a brush
and check for the motor ventilator
correct operation.
Check and in case of necessity
replace it.
Check and in case of necessity
replace it.
Call for the technician
Check for the correct mixture
balancing. Also check that it is free
from lumps and solid particles.
Strictly observe the declared
dispensing capacity
Check for the correct assembly of
the parts
Check that the moving parts (pump
and feeding needle) and the fixed
parts (tank duct – cylinder) are
clean and not worn out.
Check for the correct assembly
Reduce the quantity of air added to
the ice-cream.
Wait for a few minutes and rinse
with cold water.
ENGLISH - 26