Degas Plus / Degas Break; Exiting The Menu - ECOLAB ELADOS EMP II E60 Betriebsanleitung

PLUS
6.3 Degas / Degas Break
This menu option is used to set the Degas pause between two degassing intervals.
If a metering request is received during this time, the request is processed and the
PLUS
Degas - break time is reset and restarted.
 Choose menu option "configuration degas"
(see chapter
 Press the START/STOP key. The selection jumps to "degas strokes."
 Press the "▼" key. The black selection bar marks the menu option "degas break".
 Press the START/STOP key. The selection jumps to the settings for the break (hours).
 Select the desired break value in hours using the Up or Down key (/▼).
 Press the START/STOP key. The black selection bar marks the settings in minutes.
 Select the desired numbers of break minutes using the Up or Down key (/▼).
 Press the START/STOP key.
The settings will be applied and the display returns to "Degas Break."
6.4

Exiting the Menu

The configuration menu can be exited as follows regardless of the currently displayed
setting level or page:
 Press the key combination "MENU/EXIT" until the main menu appears on the display.
 Press the key combination "MENU/EXIT" once more and the pump returns to the
currently set operating mode and is ready for operation.
417101377_DegasPlus
6.1 "Parameter Settings - Selecting Degas
fig. 6.3
Adjustable range:
Hours 00 - 23
Minutes 00 - 59
complete 00.01 - 23.59 h
Standard setting:
00:00
PLUS
").
Rev. 4-12.14