Jungheinrich EFG-DH ac 10 Betriebsanleitung Seite 52

Reverse brake (single-pedal):
–– Switch driving direction switch (52) or (18) to opposite driving direction while driv-
ing. The truck is decelerated generatorically by means of the drive current control
system until the truck starts to travel in the opposite direction.
f
Depending on the truck type, the driving
direction switch can be locatede
–– at the Multi Pilot, (o, figure 1) or
–– at the adjustment lever, (t, figure 2).
Reversing brake (dual-pedal) o
–– While travelling, push down accelera-
tor pedal (15/17) for the opposite tra-
vel direction. By means of the drive
current controller the truck is genera-
tively braked until travel continues in
opposite direction.
Locking brake:
–– Pull back locking brake (10). The lok-
king brake is engaged and the locking
brake lever is locked into this position.
–– Press the locking knob of the locking
brake (10) and press lever forward, in
order to release the locking brake.
A
The parking brake is used to mechani-
cally brake the load wheels with the
drum brakes.
An “"Attention”" LED flashes on the multi
function display when you attempt to
start the truck with the parking brake ap-
plied. The drive motor switches off after
3 secs.
f
The parking brake holds the truck with
the highest admissible load and clean
lane on an incline of 15 %.
52
V
R
(1)
15
16
17
10
18
(2)
E 21