Jungheinrich EFG-DH ac 10 Betriebsanleitung Seite 45

Safety belt instructions
Before starting the industrial truck, pull
belt out of the winder slowly, place it over
your thighs tight to your body and close
the lock.
f
The belt must not be twisted when fas-
tening it!
When operating the industrial truck (e.g.
driving, lifting, lowering, etc.), the driver
must be seated with the back at the
backrest.
The automatic blocking system of the
belt winder gives you sufficient freedom
of movement on the seat.
f
Sitting on the front edge of the seat re-
duces the protection because of the long
belt.
A
The belt must only be used to protect
one person.
–– Press red key after use and place lock tongue back to the winder with your hand.
A
The automatic blocking system may be released if the lock tongue hits the housing.
In this case the belt cannot be pulled out.
Release blocking:
–– Pull belt 10 to 15 mm out of the housing with increased power.
–– Let the belt move in again to release the automatic blocking system.
Belt can be pulled out again.
Behaviour when starting the industrial truck on a slope
The automatic blocking system blocks the belt extension if the industrial truck is tilted
too much. The belt cannot be pulled out of the winder anymore.
A
Carefully drive industrial truck out of the slope and fasten belt.
E 14