Picking Up, Transporting And Setting Down Of Loads - Jungheinrich EFG-DH ac 10 Betriebsanleitung

6.8

Picking up, transporting and setting down of loads

m
Before a load unit is taken up the driver has to make sure, that it is correctly palettised
and that the load capacity of the truck is not exceeded.
Observe capacity label!
Adjusting fork tines
f
The fork tines must be adjusted so that
both tines have the same distance to the
outer edges of the fork carrier. The load
centre must be centred between the fork
tines.
–– Swivel locking lever (72) upward.
–– Push fork tines (70) on the fork carrier
(71) to the correct position.
–– Swivel locking lever downward and
push fork tine until it is arrested in the
groove.
Taking up load
–– Drive carefully close to the load to be
lifted.
–– Brake with the service brake and keep
the foot on the pedal or apply the park-
ing brake (10).
–– Put hoist frame into vertical position.
–– Lift fork tines to the correct height of
the load.
71
70
10
72
3
E 27