Commissioning The Truck; Checks And Actions Before Routine Start-Up; Adjustment Of Driver's Seat - Jungheinrich EFG-DH ac 10 Betriebsanleitung

5

Commissioning the truck

f
Before starting or operating the truck, or before lifting any loads, the driver has to
make sure that nobody is within the danger area.
5.1

Checks and actions before routine start-up

Prior to setting the truck into operation the driver must confirm the operationally
reliable condition. Prior to starting work the following items must be verified:
–– operation of the service and parking brakes respectively the automatic brake
(Emergency Stop)
–– no damages at the fork securing device against lifting out and shifting
–– no visible damages at the load-carrying unit (bends, cracks, severe abrasion)
–– operation of the warning equipment
5.2

Adjustment of driver's seat

A
The driver`s seat must be adjusted to the driver`s weight in order to achieve an opti-
mum damping of the seat.
The driver`s seat must be load-free when adjusting to the driver`s weight!
Adjusting the driver`s weight:
–– Pull weight adjustment “"Driver's seat”"
(13) in arrow direction until stop and
release again.
A
The previous weight adjustment is set
back to the minimum value. Adjusting
range of seat damping from 50 kg to
130 kg.
–– Pull weight adjustment “"Driver's seat”"
(13) in arrow direction again until the
appropriate weight is indicated on the
weight display “"Driver's seat”" (12).
Push weight adjustment “"Driver`s
seat”" back again.
–– Sit down on the driver`s seat.
50
11
12 13 14
E 11