Removing And Installing The Battery - Jungheinrich EFG-DH ac 10 Betriebsanleitung

5

Removing and installing the battery

–– Open battery hood (see section 3).
f
Batteries with exposed terminals or connectors must be covered with a rubber mat to
prevent short-circuits. When changing the battery with the aid of a lifting gear ensure
that the lifting gear is of adequate capacity (the battery weight is indicated on the bat-
tery identification plate at the battery trough). The lifting gear is led through the open-
ing of the overhead guard and must pull in a vertical direction to prevent damage to
the battery trough. Lifting hooks must be applied in such a way to the battery lifting
eyes that, with the lifting gear slack, they will not drop on to the battery cells.
–– Attach lifting gear to the battery trough
(9).
–– Lift battery over the frame on the right
side and pull it to the side.
–– Installation is in the reverse order.
f
When replacing batteries, ensure that a battery of the same type is fitted. After rein-
stallation of the battery, visually check all leads and connectors for damage. The cov-
ers must be securely locked.
f
During replacement/installation of the battery, pay attention that the battery is tight in
the battery box of the truck.
9
D 5