Grass Cutting - GGP ITALY 102 Gebrauchsanweisung

HOW TO USE THE MACHINE
5.4.4 Reverse
Reverse must be engaged ONLY when the machine is stopped.
Mechanical
transmission
Push down the pedal until the machine stops and then insert reverse by moving the
lever sideways and putting it into position «R». (
pedal to engage the clutch and then begin moving in reverse.
Hydrostatic transmission
When the machine is stopped, start the reverse movement by pressing the drive
pedal in the «R» direction (

5.4.5 Grass cutting

When you have reached the area to be mowed,
make sure that the grass-catcher or stone-guard is
correctly fitted and that the cutting deck wheels are
positioned at the required height.
Each wheel can be fitted at two different heights: the
low position always leaves a space between the
ground and the edge of the cutting deck to prevent
the deck from damaging the lawn if the ground is
uneven.
The higher position excludes this possibility.
To change the position, unscrew and remove the pin (1) then reposition the wheel (2) in
the upper and lower hole of the wale corresponding to the wheel diameter.
WARNING!
OFF AND THE BLADES DISENGAGED.
To start cutting:
– put the accelerator into the «FAST» position;
– bring the cutting deck to the highest position;
– only use the blade (
or when the grass is very high;
– start moving forwards onto the grass area very gradually and with particular caution,
as already described;
– adjust the forward speed and the cutting height (
dition (height, density and dampness of the grass).
WARNING!
reduced to ensure safe conditions (
4.32).
This work is to be done to all four wheels, WITH THE ENGINE
4.7), on grass lawns, do not use the blades on stony ground
When cutting on sloping ground, the forward speed must be
4.22). Gradually release the
4.10) according to the lawn con-
1.2 - 5.5).
EN
Ø 100
Ø 80
1
2
27