GGP ITALY 102 Gebrauchsanweisung Seite 58

10
EN
Line up the hole on the steering wheel hub (4)
with the hole on the shaft (3) and insert the pin
supplied (5) using a hammer, ensuring that the
end comes completely through to the opposite
side.
NOTE
steering wheel, use a punch or a screw-driver
of the same size as the pin when hammering
it in the last part.
3.3 FITTING THE SEAT
Raise the adjustment lever (3) and fit the seat
(1) in the slide (2), introducing it from the steer-
ing wheel's side, till the seat engages in one of
the 6 positions.
At this point the seat is engaged and cannot be
completely removed unless the lever (4) is
pressed, freeing it from its retainer
3.4 ASSEMBLY AND CONNECTING
THE BATTERY
Position the battery (1) in its compartment
under the seat.
Connect the red cable (2) to the positive termi-
nal (+) and the black cable (3) to the negative
terminal (–) using the supplied screws and fol-
lowing the illustrated sequence.
Fit the spring (4) to hold the battery in place
and make sure all the wires are in front of the
battery so that they don't get caught in the
spring (4).
IMPORTANT
battery according to the instructions in the
battery's manual (
To avoid damaging the
Always fully charge the
6.2.3).
UNPACKING AND ASSEMBLY
1
4
4
1
1
2
3
5
2 1 3
3
2
4