Troubleshooting - GGP ITALY 102 Gebrauchsanweisung

42
EN

7. TROUBLESHOOTING

PROBLEM
1. With the key at
«ON» the dashboard
remains off with no
audible signal
2. With the key at
«ON» the dashboard
remains off, but there
is an audible signal
3. With the key
on «START» the
dashboard comes on
but the starter motor
does not runs
4. With the key on
«START» the starter
motor runs but the
engine does not start
5. Starting is difficult
or the engine runs
erratically
6. Weak engine
performance during
cutting
7. Engine stops when
blades are engaged
LIKELY CAUSE
The protection of the electronic card
has cut in due to:
– badly connected battery
– battery terminals crossed
– completely flat battery
– fuse blown
The protection of the electronic card has
cut in due to:
– electronic card wet
– insufficiently charged battery
– battery charger fuse blown
– insufficiently charged battery
– faulty fuel supply
– faulty ignition
– fault in carburation
– forward speed too high in relation to
cutting height ( 5.4.5)
– you are not ready to engage the blades
TROUBLESHOOTING
SOLUTION
Put the key in the «OFF» position
and look for the cause of the problem:
– check connections (
– check connections (
– recharge battery (
– replace fuse (10 A) (
Put the key in the «OFF» position and
look for the cause of the problem:
– dry using tepid air
– recharge the battery (
– replace fuse (25 A) (
– recharge the battery (
– check the level in the tank (
– open the fuel stopcock (if fitted)
( 5.4.1)
– check fuel filter
– check that spark plug caps are firmly
fitted
– check that the electrodes are clean
and have the correct gap
– clean or replace the air filter
– flush out the float chamber
– empty fuel tank and refill
with fresh fuel
– check and, if necessary,
replace fuel filter
– reduce the forward speed and/or raise
the cutting deck
– check that the conditions allowing
starting are met (
3.4)
3.4)
6.2.3)
6.3.5)
6.2.3)
6.3.5)
6.2.3)
5.3.3)
5.2.c)