Grass Cutting - GGP ITALY 98SD Gebrauchsanweisung

HOW TO USE THE MACHINE
Mechanical transmission
then go into reverse by shifting the lever sideways and into position «R» (
Gradually release the pedal to engage the clutch and then begin moving in reverse.
Hydrostatic transmission
reversing by pressing the drive pedal in direction «R» (

5.4.5 Grass cutting

When you have reached the area to be
mowed, make sure that the cutting deck
wheels are positioned at the required height.
Each wheel can be fitted at two different
heights: the low position always leaves a
space between the ground and the edge of
the cutting deck to prevent the deck from
damaging the lawn if the ground is uneven.
The higher position excludes this possibility.
To change the position unscrew and remove
the pin (1) then reposition the wheel (2) in the upper and lower hole of the wale corre-
sponding to the wheel diameter.
WARNING!
OFF AND THE BLADES DISENGAGED.
To start cutting:
– move the throttle to «FAST»;
– raise the cutting deck as high as possible;
– only use the blade (
or when the grass is very high;
– start moving forwards on the grass very slowly and with utmost caution, as already
described;
– regulate the cutting height and speed (
(the height, density and dampness of the grass).
WARNING!
ensure safe conditions (
This work is to be done to both wheels, WITH THE ENGINE
4.9), on grass lawns, do not use the blades on stony ground
When cutting on sloping ground, reduce your speed to
1.2 - 5.5).
Press the pedal until the machine stops and
When the machine has stopped moving, start
4.8) considering the conditions of the lawn
4.32).
Ø 100
Ø 80
2
23
EN
4.22).
1